Route the servo wire out the top of the can gun and leave slack on the trigger wire for calibrating later. It's also useful to route out a bit of clearance in the handle itself for the wire to move. Affix with E6000 glue or epoxy and allow to dry (quadcopter foot being used in above photo as a spacer only while the glue dries).ĭrill a small hole in the trigger for affixing a wire later.Ĭut the red trigger mechanism so it fits around the motor and doesn't intersect.Īttach a wire to the horn of the motor and run it through the hole in the trigger.
Test fit your micro servo in a location where the movement can pull the can trigger. This sprayer worked well for us but there are others available online or in your local hardware store that will work just as well! Open it up to reveal the mechanism inside.
0 kommentar(er)
